These results are ranked by popularity.
Error | |
---|---|
724 | Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on. |
502 | Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect |
951 | Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal. |
601 | Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line. |
323 | Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD. |
The most common error codes.
Error | |
---|---|
724 | Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on. |
502 | Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect |
951 | Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal. |
601 | Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line. |
323 | Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD. |
724 | Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on. |
502 | Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect |
951 | Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal. |
601 | Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line. |
323 | Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD. |