These results are ranked by popularity.
Error | |
---|---|
SC544 | Description: Fusing Overheat Error 2: Hardware The fusing temperature monitoring circuit detects abnormal fusing temperature. |
SC864 | Description: HDD Error 5: Data CRC Error During HDD operation, the HDD could not respond to a CRC error query. |
SC737 | Description: Full Finisher Staple Waste Hopper (B478) The staple waste hopper is full. |
SC341 | Description: TD Sensor Error 2 (TD Sensor Control Voltage Abnormal) One of the following TD sensor output voltages is detected during TD sensor initial setting. • Less than 2.5 V when the maximum PWM (255) is applied to the TD sensor. • 2.5 V or more wh |
SC954 | Description: Printer Image Setting Error The settings that are required for image processing using the printer controller are not sent from the IPU. |
The most common error codes.
Error | |
---|---|
SC544 | Description: Fusing Overheat Error 2: Hardware The fusing temperature monitoring circuit detects abnormal fusing temperature. |
SC864 | Description: HDD Error 5: Data CRC Error During HDD operation, the HDD could not respond to a CRC error query. |
SC737 | Description: Full Finisher Staple Waste Hopper (B478) The staple waste hopper is full. |
SC341 | Description: TD Sensor Error 2 (TD Sensor Control Voltage Abnormal) One of the following TD sensor output voltages is detected during TD sensor initial setting. • Less than 2.5 V when the maximum PWM (255) is applied to the TD sensor. • 2.5 V or more wh |
SC954 | Description: Printer Image Setting Error The settings that are required for image processing using the printer controller are not sent from the IPU. |
SC737 | Description: Full Finisher Staple Waste Hopper (B478) The staple waste hopper is full. |
SC544 | Description: Fusing Overheat Error 2: Hardware The fusing temperature monitoring circuit detects abnormal fusing temperature. |
SC864 | Description: HDD Error 5: Data CRC Error During HDD operation, the HDD could not respond to a CRC error query. |
SC341 | Description: TD Sensor Error 2 (TD Sensor Control Voltage Abnormal) One of the following TD sensor output voltages is detected during TD sensor initial setting. • Less than 2.5 V when the maximum PWM (255) is applied to the TD sensor. • 2.5 V or more wh |
SC492 | Description: Development Unit Suction Motor While the development unit toner suction motor is operating, the lock sensor output does not change for 1 s. |