Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio Color 4006 Top Searches

These results are ranked by popularity.

Error
SC452Description: Transfer belt mark detection error - Timing & Condition- The main control board does not receive the belt mark detection signal from the transfer belt home position sensor for a certain period.
SC722Description: Sorter jogger motor error The jogger does not return to its home position within the specified time. The jogger does not leave home position within the specified time.
SC191Description: Bar code scan error - Timing - Just after the main switch is turned on - Condition - The scanner IPU board detects that the bar code pattern scanned in is not appropriate.
SC543Description: Hot roller fusing lamp overheat - Timing - Every 1 second when the fusing unit is installed - Condition - The hot roller thermistor output is lower than about 0.3V, which corresponds to 220 °C, for 3 seconds continuously.
SC327Description: FGATE2 error - Timing & Condition - When two pages are to be written on the transfer belt at the same time, the main control board does not receive the 2nd FGATE signal from the LD main control board during 3 revolutions of the transfer belt

Ricoh Aficio Color 4006 Common Errors

The most common error codes.

Error
SC452Description: Transfer belt mark detection error - Timing & Condition- The main control board does not receive the belt mark detection signal from the transfer belt home position sensor for a certain period.
SC722Description: Sorter jogger motor error The jogger does not return to its home position within the specified time. The jogger does not leave home position within the specified time.
SC191Description: Bar code scan error - Timing - Just after the main switch is turned on - Condition - The scanner IPU board detects that the bar code pattern scanned in is not appropriate.
SC543Description: Hot roller fusing lamp overheat - Timing - Every 1 second when the fusing unit is installed - Condition - The hot roller thermistor output is lower than about 0.3V, which corresponds to 220 °C, for 3 seconds continuously.
SC327Description: FGATE2 error - Timing & Condition - When two pages are to be written on the transfer belt at the same time, the main control board does not receive the 2nd FGATE signal from the LD main control board during 3 revolutions of the transfer belt
SC452Description: Transfer belt mark detection error - Timing & Condition- The main control board does not receive the belt mark detection signal from the transfer belt home position sensor for a certain period.
SC722Description: Sorter jogger motor error The jogger does not return to its home position within the specified time. The jogger does not leave home position within the specified time.
SC191Description: Bar code scan error - Timing - Just after the main switch is turned on - Condition - The scanner IPU board detects that the bar code pattern scanned in is not appropriate.
SC543Description: Hot roller fusing lamp overheat - Timing - Every 1 second when the fusing unit is installed - Condition - The hot roller thermistor output is lower than about 0.3V, which corresponds to 220 °C, for 3 seconds continuously.
SC327Description: FGATE2 error - Timing & Condition - When two pages are to be written on the transfer belt at the same time, the main control board does not receive the 2nd FGATE signal from the LD main control board during 3 revolutions of the transfer belt