These results are ranked by popularity.
Error | |
---|---|
726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
545 | Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating. |
744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
336 | Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off. |
822 | Description: Self-diagnostic error 3: HDD |
The most common error codes.
Error | |
---|---|
726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
545 | Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating. |
744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
336 | Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off. |
822 | Description: Self-diagnostic error 3: HDD |
744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
545 | Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating. |
726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
336 | Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off. |
822 | Description: Self-diagnostic error 3: HDD |