These results are ranked by popularity.
| Error | |
|---|---|
| E043 | Description: The PLL lock signal (DMPLK) remains ‘1’ for 2 sec or more after the deck main motor drive signal is generated. |
| E624 | Description: An error has occurred in the communication with the editor digitizer. |
| E531-0001 | Description: The stapler does not leave the stapling home position even when the stapler motor has been driven for 0.5 sec. |
| E006-0001 | Description: The fixing drawer cannot be detected even though the 24-V door is closed |
| E5F1-0001 | Description: The number of detention pulses of the folding motor clock sensor drops to a specific value or lower. |
The most common error codes.
| Error | |
|---|---|
| E043 | Description: The PLL lock signal (DMPLK) remains ‘1’ for 2 sec or more after the deck main motor drive signal is generated. |
| E624 | Description: An error has occurred in the communication with the editor digitizer. |
| E531-0001 | Description: The stapler does not leave the stapling home position even when the stapler motor has been driven for 0.5 sec. |
| E006-0001 | Description: The fixing drawer cannot be detected even though the 24-V door is closed |
| E5F1-0001 | Description: The number of detention pulses of the folding motor clock sensor drops to a specific value or lower. |
| E531-0001 | Description: The stapler does not leave the stapling home position even when the stapler motor has been driven for 0.5 sec. |
| E624 | Description: An error has occurred in the communication with the editor digitizer. |
| E043 | Description: The PLL lock signal (DMPLK) remains ‘1’ for 2 sec or more after the deck main motor drive signal is generated. |
| E219 | Description: The thermistor reading is 150°C or higher while the scanning lamp is on |
| E800-0001 | Description: The shut-off relay of the main power switch (SW1) is found to have an open circuit. |
