Konica-Minolta Di30 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Di30 Top Searches

These results are ranked by popularity.

Error
C0510Description: Abnormally low fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 140°C or less for 1 sec. or more after the warm-up cycle has been completed.
C0B10Description: ST-204, FN-2 Defective Paper Clamp Motor
C0000Description: Main Drive Motor M1 Overload, defective motor The LOCK signal is not detected for 1 sec. or more after the motor has been energized. The LOCK signal is not detected for 0.5 sec. or more after the motor speed has built up to the constant ran
C0520Description: Abnormally high fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 220°C or more for 1 sec. or more after the warm-up cycle has been completed.
C0B20Description: ST-204 Defective Elevator Motor

Konica-Minolta Di30 Common Errors

The most common error codes.

Error
C0510Description: Abnormally low fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 140°C or less for 1 sec. or more after the warm-up cycle has been completed.
C0B10Description: ST-204, FN-2 Defective Paper Clamp Motor
C0000Description: Main Drive Motor M1 Overload, defective motor The LOCK signal is not detected for 1 sec. or more after the motor has been energized. The LOCK signal is not detected for 0.5 sec. or more after the motor speed has built up to the constant ran
C0520Description: Abnormally high fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 220°C or more for 1 sec. or more after the warm-up cycle has been completed.
C0B20Description: ST-204 Defective Elevator Motor
C0510Description: Abnormally low fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 140°C or less for 1 sec. or more after the warm-up cycle has been completed.
C0B10Description: ST-204, FN-2 Defective Paper Clamp Motor
C0000Description: Main Drive Motor M1 Overload, defective motor The LOCK signal is not detected for 1 sec. or more after the motor has been energized. The LOCK signal is not detected for 0.5 sec. or more after the motor speed has built up to the constant ran
C0520Description: Abnormally high fusing temperature Defective heater lamp, defective thermistor, heater lamp out The temperature remains 220°C or more for 1 sec. or more after the warm-up cycle has been completed.
C0B20Description: ST-204 Defective Elevator Motor