Error |
---|
These results are ranked by popularity.
Error | |
---|---|
7614 | Description: Bias calibration reading value error (Yellow) During the calibration, the ID sensor cannot read a patch density on the primary transfer belt normally. |
8900 | Description: Document finisher backup error Mismatch between writing data and reading data occurs 3 times successively. |
F58X ... F5EX | Description: An error is detected at the Device control section |
6020 | Description: Fuser thermistor 1 High temperature error The temperature detected by the thermistor 1 (center) exceeded 240 °C/464.0 °F for 1s in succession. |
2101 | Description: Developer motor steadystate error (BK) After the motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
The most common error codes.
Error | |
---|---|
7614 | Description: Bias calibration reading value error (Yellow) During the calibration, the ID sensor cannot read a patch density on the primary transfer belt normally. |
8900 | Description: Document finisher backup error Mismatch between writing data and reading data occurs 3 times successively. |
F58X ... F5EX | Description: An error is detected at the Device control section |
6020 | Description: Fuser thermistor 1 High temperature error The temperature detected by the thermistor 1 (center) exceeded 240 °C/464.0 °F for 1s in succession. |
2101 | Description: Developer motor steadystate error (BK) After the motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
2101 | Description: Developer motor steadystate error (BK) After the motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
F58X ... F5EX | Description: An error is detected at the Device control section |
6020 | Description: Fuser thermistor 1 High temperature error The temperature detected by the thermistor 1 (center) exceeded 240 °C/464.0 °F for 1s in succession. |
8900 | Description: Document finisher backup error Mismatch between writing data and reading data occurs 3 times successively. |
7614 | Description: Bias calibration reading value error (Yellow) During the calibration, the ID sensor cannot read a patch density on the primary transfer belt normally. |