These results are ranked by popularity.
Error | |
---|---|
SC562-03 | Description: Pressure (Center) thermistor not reloaded The pressure (Center) thermistor does not reach 60 deg C 39 seconds after the start of motor rotation. |
SC491-02 | Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec |
SC995-02 | Description: CPM setting error 2 Comparison of machine serial number (11 digits) and machine identification code. Details: Machine serial number cannot be identified because of NV-RAM replacement or malfunctioning. |
SC841-00 | Description: EEPROM read data error Mirrored data of the EEPROM is different from the original data in EEPROM. |
SC144-00 | Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE) |
The most common error codes.
Error | |
---|---|
SC562-03 | Description: Pressure (Center) thermistor not reloaded The pressure (Center) thermistor does not reach 60 deg C 39 seconds after the start of motor rotation. |
SC491-02 | Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec |
SC995-02 | Description: CPM setting error 2 Comparison of machine serial number (11 digits) and machine identification code. Details: Machine serial number cannot be identified because of NV-RAM replacement or malfunctioning. |
SC841-00 | Description: EEPROM read data error Mirrored data of the EEPROM is different from the original data in EEPROM. |
SC144-00 | Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE) |
SC562-03 | Description: Pressure (Center) thermistor not reloaded The pressure (Center) thermistor does not reach 60 deg C 39 seconds after the start of motor rotation. |
SC491-02 | Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec |
SC995-02 | Description: CPM setting error 2 Comparison of machine serial number (11 digits) and machine identification code. Details: Machine serial number cannot be identified because of NV-RAM replacement or malfunctioning. |
SC841-00 | Description: EEPROM read data error Mirrored data of the EEPROM is different from the original data in EEPROM. |
SC144-00 | Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE) |