Toshiba e-Studio 450 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Toshiba e-Studio 450 Top Searches

These results are ranked by popularity.

Error
CB40Description: Rear aligning plate motor abnormality: Rear aligning plate motor is not rotating or aligning plate is not moving normally. [MJ-1023/1024]
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
E743Description: Jam not reaching the exit sensor (during reverse feeding): The original does not reach the exit sensor after it has passed the reverse sensor when the original is exited from the reverse section.
CC60Description: Punch motor abnormality: Punch motor is not rotating or puncher is not shifting normally. [MJ-1023/1024 (when MJ-6004 is installed)]
EA60Description: Early arrival jam: The inlet sensor detects the paper earlier than a specified timing. [MJ-1022]

Toshiba e-Studio 450 Common Errors

The most common error codes.

Error
CB40Description: Rear aligning plate motor abnormality: Rear aligning plate motor is not rotating or aligning plate is not moving normally. [MJ-1023/1024]
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
E743Description: Jam not reaching the exit sensor (during reverse feeding): The original does not reach the exit sensor after it has passed the reverse sensor when the original is exited from the reverse section.
CC60Description: Punch motor abnormality: Punch motor is not rotating or puncher is not shifting normally. [MJ-1023/1024 (when MJ-6004 is installed)]
EA60Description: Early arrival jam: The inlet sensor detects the paper earlier than a specified timing. [MJ-1022]
CB40Description: Rear aligning plate motor abnormality: Rear aligning plate motor is not rotating or aligning plate is not moving normally. [MJ-1023/1024]
E743Description: Jam not reaching the exit sensor (during reverse feeding): The original does not reach the exit sensor after it has passed the reverse sensor when the original is exited from the reverse section.
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
E440Description: Side cover open jam: The side cover has opened during printing.
CC60Description: Punch motor abnormality: Punch motor is not rotating or puncher is not shifting normally. [MJ-1023/1024 (when MJ-6004 is installed)]