Error |
---|
These results are ranked by popularity.
Error | |
---|---|
C890 | Description: RADF read motor abnormality: An error signal has been detected when the motor is rotating. |
CBB0 | Description: Stitch motor (rear) abnormality: Stitch motor (rear) is not rotating or rotary cam is not moving normally. [MJ-1103/1104] |
EF24 | Description: Hole Punch Unit paper trailing edge skew detection abnormality |
E722 | Description: Jam not reaching the original exit sensor (during scanning): The original which passed the read sensor does not reach the original exit/reverse sensor when it is transported from the scanning section to exit section. |
C443 | Description: Heater lamp abnormality after abnormality judgment (not reaching to intermediate temperature) |
The most common error codes.
Error | |
---|---|
C890 | Description: RADF read motor abnormality: An error signal has been detected when the motor is rotating. |
CBB0 | Description: Stitch motor (rear) abnormality: Stitch motor (rear) is not rotating or rotary cam is not moving normally. [MJ-1103/1104] |
EF24 | Description: Hole Punch Unit paper trailing edge skew detection abnormality |
E722 | Description: Jam not reaching the original exit sensor (during scanning): The original which passed the read sensor does not reach the original exit/reverse sensor when it is transported from the scanning section to exit section. |
C443 | Description: Heater lamp abnormality after abnormality judgment (not reaching to intermediate temperature) |
E722 | Description: Jam not reaching the original exit sensor (during scanning): The original which passed the read sensor does not reach the original exit/reverse sensor when it is transported from the scanning section to exit section. |
EF24 | Description: Hole Punch Unit paper trailing edge skew detection abnormality |
EA28 | Description: Paper transport jam (assisting arm operation delay): [MJ-1103/1104] |
E2B1 | Description: Stop jam at the registration sensor (2nd drawer) |
CBB0 | Description: Stitch motor (rear) abnormality: Stitch motor (rear) is not rotating or rotary cam is not moving normally. [MJ-1103/1104] |