Xerox Phaser 7800 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox Phaser 7800 Top Searches

These results are ranked by popularity.

Error
312.282Description: Eject Clamp Home Sensor Off Fault. BSD-ON: Set Eject Control (1 of 2) After the Eject Clamp started descending, the Eject Clamp Home Sensor did not turn Off within 200ms.
341.347Description: Serial I/O Fault.
375.103Description: Tray 1 Feed Out Sensor Off Jam. The Tray 1 Feed Out Sensor does not turn Off within the specified time after the Reg Clutch On.
393.970Description: Toner Y CRUM Not In Position. The Toner CRUM (Y) is not in the proper position.
312.231Description: Puncher Home Sensor On Fault. The Puncher Home Sensor did not turn On within the specified time after the Puncher Motor started running.

Xerox Phaser 7800 Common Errors

The most common error codes.

Error
312.282Description: Eject Clamp Home Sensor Off Fault. BSD-ON: Set Eject Control (1 of 2) After the Eject Clamp started descending, the Eject Clamp Home Sensor did not turn Off within 200ms.
341.347Description: Serial I/O Fault.
375.103Description: Tray 1 Feed Out Sensor Off Jam. The Tray 1 Feed Out Sensor does not turn Off within the specified time after the Reg Clutch On.
393.970Description: Toner Y CRUM Not In Position. The Toner CRUM (Y) is not in the proper position.
312.231Description: Puncher Home Sensor On Fault. The Puncher Home Sensor did not turn On within the specified time after the Puncher Motor started running.
312.282Description: Eject Clamp Home Sensor Off Fault. BSD-ON: Set Eject Control (1 of 2) After the Eject Clamp started descending, the Eject Clamp Home Sensor did not turn Off within 200ms.
341.347Description: Serial I/O Fault.
375.103Description: Tray 1 Feed Out Sensor Off Jam. The Tray 1 Feed Out Sensor does not turn Off within the specified time after the Reg Clutch On.
393.970Description: Toner Y CRUM Not In Position. The Toner CRUM (Y) is not in the proper position.
312.231Description: Puncher Home Sensor On Fault. The Puncher Home Sensor did not turn On within the specified time after the Puncher Motor started running.